ServicesWhole-Home Filtration
Whole-Home Filtration in Wyldwood
Our whole-home systems mount on your main water line, so the water reaching your showers, faucets, washer and water heater is already filtered. We test first, size the unit to your house, and install it with the main shut off, floors covered and your electrical ground kept connected.

How a whole-home filter works
The filter goes on the main line, right where water enters your home. Ours mostly use carbon, which pulls out chlorine and many of the compounds that cause bad taste and smell. Ahead of the carbon sits a sediment filter that traps sand and grit, so the carbon is not doing that dirty work.
Choose this when chlorine bugs you in the shower and the laundry, not only in your glass. If the only water you worry about is what you drink and cook with, one of our Reverse Osmosis Systems under the kitchen sink may do the job for less money.
We want test results in hand before we recommend any equipment. The free test shows whether carbon is enough on its own, or whether hardness or another issue points to a different fix.
What you get with the install
Testing comes first
At your kitchen sink we measure chlorine, hardness, pH and a few other basics. You watch the readings with us. If a filter will not change anything, you hear that from us straight.
Sized for your household
We pick the tank based on your bathroom count and how much water gets used at the same time. Undersize it and the shower weakens when someone else turns on a tap. Oversize it and you pay for media you will never use.
Installation at no charge
We do not charge for the install. You pay for the equipment, and before any work starts we go over each line of the quote by phone and in writing.
A bypass valve on every system
The bypass lets you route water around the filter with one turn of a handle. That way you can change a cartridge or have pipe work done and still keep water in the house.
Your electrical ground kept whole
Lots of homes use the copper water line to ground the electrical panel. Cutting into it can break that path. So before the saw touches the pipe, we clamp a jumper wire across the spot, and your ground stays intact the whole time.
Flushing, pressure check and haul-away
We run water through the new carbon until it comes out clear, then check each joint with the line under pressure. Boxes, wrap and pipe offcuts leave with us.

When filtering the whole house is worth it
- Bathroom smells like bleach
- Hot shower water lets chlorine escape into the air you breathe. A filter on the kitchen faucet does nothing for that.
- Every faucet tastes the same, and not good
- If you keep bottled water around because no tap tastes right, treating the water at the main line fixes all of them in one step.
- Sand in your aerators
- Grit in faucet screens or a clogged showerhead tells you particles are riding in with the water. The sediment stage at the main line stops them before they reach a single fixture or appliance.
- Appliances you want to last
- Sediment wears on water heaters, dishwashers and washing machines. One filter at the main line keeps it out of all of them.
- No idea what is in your water
- That is reason enough to have it tested. You get real numbers before you buy anything.
How install day goes
- 1
Walk-through and setup
We find the main line, usually in the garage or near the outside hose bib, and confirm where the system will sit. Drop cloths go down along our path.
- 2
Water off, line cut
We shut off the main, drain the line and cut in. Before we cut, we clamp on the ground jumper so nobody touches a live pipe.
- 3
Mount and connect
We set the tanks level, plumb in the pre-filter, filter and bypass, and secure everything so it will not shift.
- 4
Flush and test
We open the water slowly, flush the new media and check every fitting for drips. Then we test the water again so you can see the change.
- 5
Show you the system
We show you the bypass, the shutoffs and when to swap the pre-filter cartridge. Most installs take part of one day, and you have water back the same afternoon.
What sets the price of a whole-home system
We install it free, so what you pay is mostly the equipment, plus any extra plumbing your house turns out to need. After the test you get a written breakdown, line by line. If something changes on install day, we stop and ask before adding a dime.
- Tank size
- More people and more bathrooms mean more water moving at the same moment. That takes a bigger tank, so a shower upstairs keeps its flow while the washer fills downstairs.
- Which carbon goes in
- Regular carbon does a good job on chlorine. If your test finds chloramine instead, catalytic carbon handles it better, and it costs more.
- Getting to the main line
- A line that is out in the open in the garage is quick work. One under a slab or behind a finished wall needs more time, more fittings and sometimes wall repair.
- What your test results call for
- Now and then a home needs a softener or a salt-free conditioner paired with the filter. We bring that up only when your hardness reading backs it up.
Common questions about whole-home filters
- Will my water pressure drop after the install?
- It should not, as long as the tank fits your house. We size it for your busiest moment, say two showers and the dishwasher going together. Pressure problems almost always trace back to a tank that is too small, and sizing is how we avoid that.
- Will it take lead out of my water?
- This is not the right tool for lead. Lead tends to come from older pipes, solder and fixtures inside the house, which sit downstream of the filter. An under-sink reverse osmosis unit protects your drinking water better, and we can test for lead before you decide.
- Should I get a softener too?
- Often you do not need one. A lot of water is only a little hard. We measure hardness during the test, and if the number is low, we will say so and you can skip the softener.
- What upkeep does the system need?
- You replace the sediment cartridge every few months, depending on your water and how much you use. The carbon in the big tank goes a lot longer. We walk you through the cartridge swap, which takes a few minutes with the bypass turned.
- What warranty comes with it?
- We back the systems we install with a lifetime warranty on tanks and ceramic discs, 5 years on the control valve, circuit board and filter media, and 1 year on labor. We go over which parts apply when we give you the quote.

Find out what is in your water first
We test at your tap and give you a straight answer on whether filtering the whole house is a good use of your money. If it is, you get a written quote and we install it free.